The Federal Aviation Administration (FAA) required a Vulcan mishap investigation on November 16, 2026, following the loss of United Launch Alliance’s Amazon Leo mission. United Launch Alliance (ULA) will lead the investigation under FAA oversight, including agency review of its final report and corrective actions.
In a November 17 update, ULA reported preliminary indications of low booster performance shortly after liftoff. The company said the vehicle separated its stages below the altitude and speed needed for the upper stage to complete the orbital mission.
Amazon’s mission record confirms the loss of the 40 satellites aboard LV-01, the company’s first Vulcan launch. It records liftoff at 12:40 p.m. Eastern Standard Time on November 15 from Space Launch Complex 41 at Cape Canaveral Space Force Station, Florida. The spacecraft were intended for Amazon’s low Earth orbit broadband network.
Early Data Points to the First Stage
The update, issued at 9:30 a.m. EST, distinguished the apparent start of the problem from the loss of telemetry, the measurements transmitted to ground teams. ULA said telemetry and the mission appeared to have been lost about 10 minutes after launch, but the performance shortfall appeared much earlier.
ULA said Centaur V appeared to start normally and its RL10 engines operated as planned, but the upper stage could not compensate for the earlier performance loss. The company also reported apparently normal solid rocket booster performance after nozzle improvements installed for this mission. These are preliminary findings from ULA’s flight-data review.
The rocket’s VC6L flight configuration combined a liquid-fueled first stage with six side-mounted solid rocket boosters and a Centaur V upper stage. Two BE-4 engines powered the first stage. The solid boosters supplied additional thrust during ascent, then separated after exhausting their propellant.
Centaur was assigned the subsequent acceleration and orbital placement. Its planned sequence included an initial engine firing, an orbital coast and a second firing before satellite deployment began approximately 70 minutes after liftoff. The upper stage’s task depended on the altitude and velocity delivered by the preceding ascent.
The mission had also been Vulcan’s return to flight after a February solid-booster nozzle anomaly. Before the November launch, ULA described design and manufacturing changes supported by material analysis, component tests and a full-scale motor firing. The November 17 finding of apparently normal solid-booster performance is part of the new investigation.
FAA Activated Two Debris Response Areas
The FAA’s November 16 statement also described its response to falling debris. It activated two Debris Response Areas and briefly slowed aircraft outside the affected area or held aircraft at their departure locations.
The agency activates these areas when an abnormal launch produces unplanned debris outside the airspace already closed for the mission. Controllers direct aircraft out of the response area, prevent other flights from entering and can hold departures at affected airports.
The Investigation and Return-to-Flight Process
The FAA’s mishap response procedures require licensed operators to preserve data and physical evidence, implement their approved mishap plans and report the event. A preliminary written report is due within five days. The investigation determines the cause and identifies measures intended to prevent a recurrence.
The agency describes two routes back to flight. Under the first, it accepts the completed investigation report, then the operator implements the corrective actions and satisfies the relevant licensing requirements before resuming operations.
Under the second, an operator can request a return-to-flight determination before the investigation is finished. That request must demonstrate that preventive measures have been implemented and that the mishap did not jeopardize public safety, or that the resulting safety risks have been sufficiently reduced. The FAA can authorize flights with the investigation still open, provided applicable licensing requirements continue to be met.
New Space Economy’s earlier mission-loss report covered the payload loss and the start of ULA’s investigation. The FAA’s subsequent statement establishes the regulatory oversight, and ULA’s November 17 update adds its preliminary assessment of the ascent.
For Vulcan, the FAA’s stated return-to-flight condition is a determination that the systems, processes or procedures associated with the mishap do not adversely affect public safety.


